Samsung NX OfficeServ 7400, OfficeServ 7200, OfficeServ 500, OfficeServ 100, OfficeServ SOHO, DCS/ DCS Compact, NX....
- After a set of ?9? until the connection to the external line passes 4-5 sec. How to get rid of this? [NX1232]
- Can Samsung NX-308 any variant to associate with other Samsung PBXs into a single internal network?
- Does the Samsung NX PBX 1232 function call with employees outside the normal phone lines?
- Help, please, to install function redirect incoming calls to another city number in Samsung NX-820.
- How many combinations are allowed at the NH-1232 can be entered in the MMC 61?
- How to configure the PBX Samsung 820-NX, so that during the day, all calls come to the system or to other phones in the group, and in the evening only to a separate room (fax)?
- How to implement remote programming / SMDR to PBX NX1232 as follows: ATS - modem - PC?
- How to increase MMS OUT time in the code "50" to 250 seconds at Samsung NX?
- How to Link with the Samsung NX System?
- How to make consecutive calls coming from the city line in the NX-1232?
- How to program the weekend day mode on NX-308?
- How to write a message for DISA on Samsung NX 1232?
- Is it possible for NX 308-X to ensure that three members came to the Secretary (201) then went on line 1 ?203?, the other two in the ?205?, and ?on of non? go to the ?207??
- Is it possible to make sure that every employee of the company had its own code to regional line access?
- Is it possible to redirect the call to an unused external line?
- Is the distribution of the priorities of external lines on NX820?
- Lost your password from a technical PBX SAMSUNG NX-1232. How to restore the original <4321>?
- NX-308. Do not pass an external incoming call on the first line (system phone).
- NX-820. How to prohibit access to regional lines all the internal numbers, with the exception of a few?
- Often, the countdown to the system call, the phone starts earlier than the complete set of numbers called. [NX 1232]
- Prompt, please, that are written in columns ACC.CODE AUTH, they are always empty for some reason.
- Signal weakening on all eight incoming lines on NX-1232
- The NX-1232 is programmed command 24 (barge-in). How does this team and how to use it now?
- There are two fax, Panasonic and Brother, connecting to Samsung NX820. How to make them work?
- What features should be switched on Samsung NX-1232 for programming the intercom and open the door locks?
- What is an issue for the column TRK, it meets the codes 704, 702, 705?
- What?s the first steps connecting PBX NX1232?
- Where is programmed the call to the system phone at Samsung NX?